Skip to main content

AC Response of Inductor

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

2


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Observe inductor current lagging a sinusoidal voltage by one quarter-cycle, and calculate inductive reactance.

Circuit notes

AC Response of Inductor

Observe inductor current lagging a sinusoidal voltage by one quarter-cycle, and calculate inductive reactance. Each source has a 1 V peak sinusoidal output. All branches share one ideal voltage source at 100 Hz.

Inductors respond to the integral of voltage: current changes fastest when the voltage magnitude is greatest.

Calculate the response

vL=LdidtXL=2πfLIpk=Vpk2πfL\begin{aligned} v_L&=L\frac{di}{dt}\\ X_L&=2\pi fL\\ I_{\mathrm{pk}}&=\frac{V_{\mathrm{pk}}}{2\pi fL} \end{aligned}
BranchValueFrequencyPeak current
L1100 mH100 Hz15.915 mA
v(t)=Vpkcos⁡(2πft)i(t)=Ipksin⁡(2πft)\begin{aligned} v(t)&=V_{\mathrm{pk}}\cos(2\pi f t)\\ i(t)&=I_{\mathrm{pk}}\sin(2\pi f t) \end{aligned}

Current lags voltage by 90°, or one quarter-cycle. At 100 Hz, one cycle is 10 ms and one quarter-cycle is 2.5 ms. All tabulated amplitudes are peak, not RMS; divide by 2\sqrt{2} for RMS.

Read the schematic and chart

The green V probe reads the shared voltage. The blue I probe measures current into the upper component terminal. A negative current means flow opposite the probe arrow.

The chart stacks voltage above current so volts and amperes have separate scales. The saved view shows 10–40 ms; the simulation runs from 0 to 40 ms with a 10 µs maximum step. Open Table for matching time samples and named columns. Compare a voltage maximum with the nearest current zero crossing.

Each source uses Phase = 90°, so its sine waveform begins at a cosine peak. Use initial conditions is enabled. Capacitors start at 1 V and inductors at 0 A; those values match the chosen steady sinusoid and avoid an artificial charging impulse or DC current offset. Initial samples are outside the saved chart view.

Try two changes

  1. Double V1 → Frequency from 100 to 200 Hz and run again. Each peak current halves, and each waveform completes twice as many cycles. Restore the original frequencies.
  2. Double every inductor’s Inductance and run again. Peak current halves at the same frequency. Restore the displayed values afterward.

Model assumptions

These are ideal linear components and ideal sources. The reactive component exchanges energy with the source and consumes zero average real power in this ideal model. Real parts add leakage, winding resistance, ESR and parasitic reactance; inductors can saturate. The chosen initial energy is intentional and does not model connecting an unenergized part to a live source.

Components used

Components used
2 components
NameManufacturerMPNCountType

AC Voltage Source

Generic

—

1

Official

Inductor

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.