Notch Filter
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
AC sweep
Copies
Not copied yet
About this circuit
Use a series LC branch to shunt a narrow frequency region to ground, creating a passive rejection notch.
Circuit notes
Notch Filter
Use a series LC branch to shunt a narrow frequency region to ground, creating a passive rejection notch.
Schematic and stimulus
V1 on the left supplies an AC analysis magnitude of 1 V and phase of 0°. R1 (100 Ω) feeds the output along the top. L1 (10 mH) and C1 (1 µF) form a series shunt from the output to ground on the right.
Vin is green, Vout is red and Iin is blue. Current is positive from the source into the network.
Expected response
With and :
At resonance the inductor and capacitor reactances cancel. The ideal series LC branch becomes a short to ground, so Vout has a theoretical zero. Far below and above the notch it approaches the 1 V input. The notch is a voltage rejection feature; source current is largest at its center.
The −3 dB rejection-band edges are approximately 983.63 Hz and 2.5752 kHz. The logarithmic sweep does not land exactly on the null; the plotted minimum is finite. Phase changes rapidly around the null and is undefined at an exact zero.
Read the Bode chart
The saved AC sweep runs from 100 Hz to 10 kHz, with 100 points per decade. Voltage magnitude and phase are shown separately. Current is hidden from the default chart to keep the voltage-gain scale readable; enable Iin in the chart series controls and expand the magnitude-axis range to plot it. Open Table for all 201 frequency samples and the same probe order. Because the input is 1 V, output voltage in dBV has the same numeric value as voltage gain in dB. Current magnitude is in dBA referenced to 1 A, so it is not a voltage gain.
AC sweep computes a sinusoidal steady state at every frequency; it does not show startup. AC analysis magnitude and AC analysis phase control this sweep. The source's Frequency and Peak voltage properties apply to transient simulation instead.
Try two changes
- Change C1 → Capacitance from 1u to 2u. Run again: the center moves to 1.1254 kHz. Restore 1u.
- Change R1 → Resistance from 100 to 200. Run again: the center stays at 1.5915 kHz, while the rejection band widens and Q falls to 0.5. Restore 100.
Click Run simulation after each change. Keep V1's AC analysis magnitude at 1 and phase at 0, then restore all component values above to return to the saved response.
Model limits
The source, resistor, capacitor and inductor models are ideal. Probes draw no current. Source impedance, component tolerance, parasitic resistance/capacitance and external loading are omitted; these can shift cutoff and reduce rejection.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.