Crossover
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
AC sweep
Copies
Not copied yet
About this circuit
Split an audio signal into low and high frequency branches with a first-order passive speaker crossover.
Circuit notes
Crossover
Split an audio signal into low and high frequency branches with a first-order passive speaker crossover.
Schematic and stimulus
V1 on the left supplies an AC analysis magnitude of 1 V and phase of 0°. The upper branch has L1 = 1.6 mH in series with an 8 Ω woofer load R1. The lower has C1 = 25 µF in series with an 8 Ω tweeter load R2. Both branches share V1; separate ground symbols share the source return. The resistors represent speaker impedances.
Expected response
Vwoofer is green, Vtweeter is red and source current Iin is blue. The inductor blocks high frequencies from the woofer; the capacitor blocks low frequencies from the tweeter.
At crossover each load receives 0.7071 V (−3.0103 dB). Woofer voltage lags by 45°, while tweeter voltage leads by 45°. Because , their complex voltage transfers sum to one, and total source current is 125 mA, in phase with the input, throughout this ideal sweep. This electrical sum is not a complete acoustic loudspeaker model.
Read the Bode chart
The saved AC sweep runs from 100 Hz to 10 kHz, with 100 points per decade. Voltage magnitude and phase are shown separately. Current is hidden from the default chart to keep the voltage-gain scale readable; enable Iin in the chart series controls and expand the magnitude-axis range to plot it. Open Table for all 201 frequency samples and the same probe order. Because the input is 1 V, output voltage in dBV has the same numeric value as voltage gain in dB. Current magnitude is in dBA referenced to 1 A, so it is not a voltage gain.
AC sweep computes a sinusoidal steady state at every frequency; it does not show startup. AC analysis magnitude and AC analysis phase control this sweep. The source's Frequency and Peak voltage properties apply to transient simulation instead.
Try two changes
- Change R1 and R2 → Resistance from 8 to 16. Run again: the woofer cutoff rises to 1.5915 kHz, while the tweeter cutoff falls to 397.89 Hz. The overlapping bands show why a crossover depends on speaker impedance. Restore both to 8.
- Change L1 → Inductance from 1.6m to 3.2m and C1 → Capacitance from 25u to 50u. Run again: both cutoffs halve to 397.89 Hz and remain matched. Restore 1.6m and 25u.
Click Run simulation after each change. Keep V1's AC analysis magnitude at 1 and phase at 0, then restore all component values above to return to the saved response.
Model limits
The loads are constant 8 Ω resistors. Real speaker impedance varies with frequency and includes resonance and voice-coil inductance; drivers also have their own acoustic response, polarity and placement. The inductors/capacitors are lossless and the source impedance is zero.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.