Differentiator
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Turn each rising and falling edge of a square wave into a short pulse using a passive RC differentiator.
Circuit notes
Differentiator
Turn each rising and falling edge of a square wave into a short pulse using a passive RC differentiator.
V1 applies 0–5 V pulses through C1 = 10 nF to R1 = 1 kΩ. Vout is measured across R1; Iin is the capacitor and resistor current. The pulse begins at 0.2 ms, lasts 0.5 ms and repeats every 1 ms. Both edges take 1 µs.
The derivative approximation applies when the input changes slowly compared with RC. For these sharp edges, use the full high-pass response: each edge creates a pulse that decays with the 10 µs time constant. Rising edges give positive pulses and falling edges negative pulses. Finite rise time makes the peaks about ±4.76 V, slightly below the 5 V input change.
Read the chart. The voltage panel compares Vin in green with Vout in red. The current panel shows Iin in blue. The 2 ms view includes two complete input pulses; the 0.2 µs simulation step resolves the narrow output peaks.
Try it. Change C1’s Capacitance to 20 nF, run again, and compare pulse width. The time constant doubles. Restore 10 nF.
Model limits. The input source, resistor and capacitor are ideal. A real differentiator also responds to noise; parasitic resistance and finite source bandwidth limit its fastest edges.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.