Wheatstone Bridge
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
2
Schematic
Yes
Simulation
DC operating point
Copies
Not copied yet
About this circuit
Compare two resistor ratios and detect a small imbalance with a bridge current measurement.
Circuit notes
Wheatstone Bridge
Compare two resistor ratios and detect a small imbalance with a bridge current measurement.
The 5 V source feeds two upright voltage dividers. R1/R2 form the left arm and R3/R4 the right arm. RM = 100 Ω models a detector between their midpoints. Vleft and Vright measure those midpoint voltages; Ibridge is positive from left to right.
With all four arm resistors at 1 kΩ the bridge is balanced. Its detector draws no current even though each divider draws supply current. Bridge circuits convert a resistance change, such as a sensor change, into an electrical imbalance.
Try it. Change R4’s Resistance to 1.2 kΩ. The right midpoint rises and Ibridge becomes negative: current flows right to left. RM loads both dividers, so their actual midpoint voltages differ from the unloaded divider calculations. Restore R4 to 1 kΩ.
Read the results. Run the operating-point simulation after a change. The comfortable results table reports both node voltages and the detector current. The current sign indicates imbalance direction.
Model limits. Resistor tolerances, detector offset, noise and temperature drift are omitted. This example measures electrical balance, not a calibrated physical sensor.
Components used
Components used
2 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.