LC Ladder
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
AC sweep
Copies
Not copied yet
About this circuit
Cascade three LC sections to form a passive low-pass ladder and examine the effect of its termination.
Circuit notes
LC Ladder
Cascade three LC sections to form a passive low-pass ladder and examine the effect of its termination.
Three identical cells connect series inductors of 10 mH to shunt capacitors of 1 µF. RS = 100 Ω is the source resistance and RL = 100 Ω the termination. Vin is measured before RS; Vout is measured at RL. The lower bus is the shared return.
The cutoff expression describes an ideal repeated constant-k ladder and is a useful scale for this finite three-cell network. The actual loaded response comes from the complete circuit. At low frequency, the two resistances divide the input, so the output begins near −6.02 dB. At high frequency, the inductors impede current and the capacitors shunt it toward ground.
Read the chart. The Bode plot sweeps 100 Hz to 10 kHz. Vin is the 0 dB reference and Vout shows the loaded gain and phase. Current is available in the table and chart series controls. A phase wrap at ±180° is an equivalent angle, not a discontinuity in the circuit.
Try it. Change all three Capacitance values to 2 µF. The transition moves lower by approximately a factor of √2 and the nominal impedance changes. Restore all three to 1 µF. Changing only one creates a different, nonuniform ladder.
Model limits. Components are lossless except for the source and load resistors. Real coil resistance and parasitic capacitance change the insertion loss and high-frequency response.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.