Skip to main content

Zener I/V Curve

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

2


Schematic

Yes


Simulation

DC sweep


Copies

Not copied yet

About this circuit

Compare ordinary forward conduction with the controlled reverse-breakdown region of a Zener diode.

Circuit notes

Zener I/V Curve

Compare ordinary forward conduction with the controlled reverse-breakdown region of a Zener diode.

V1 sweeps the diode's anode-to-cathode voltage from −5.12 V to +0.60 V in 5 mV increments. D1 has a 5.1 V breakdown setting, 20 mA breakdown current, 1 pA saturation current and forward emission coefficient 1. Id is positive from anode to cathode; reverse-breakdown current is negative.

ID≈IS(eVD/(nVT)−1)(forward region)I_D\approx I_S\left(e^{V_D/(nV_T)}-1\right)\quad\text{(forward region)} VD≈−VZ(reverse breakdown)V_D\approx-V_Z\quad\text{(reverse breakdown)}

Read the negative-voltage end of the current plot for the breakdown knee, and the positive end for ordinary diode conduction. Between them, very little current flows. The voltage panel confirms the swept bias. The table gives individual samples, including currents too small to distinguish on the linear plot.

Model limits. The ideal voltage source is a curve-tracer stimulus. A physical measurement needs current compliance or a limiting resistor. The XSPICE Zener model describes a smooth electrical characteristic; it does not predict temperature rise, damage, noise or a manufacturer's full tolerance range.

Try it. Set D1 breakdown voltage to 5.6 V; the reverse knee moves outside the saved sweep. Restore the original values after comparing the results.

Components used

Components used
2 components
NameManufacturerMPNCountType

DC Voltage Source

Generic

—

1

Official

Zener Diode

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.