Zener Voltage Reference with Follower
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
DC operating point
Copies
Not copied yet
About this circuit
Use an emitter follower to supply load current while reducing the current drawn from a Zener reference.
Circuit notes
Zener Voltage Reference with Follower
Use an emitter follower to supply load current while reducing the current drawn from a Zener reference.
V1 supplies 12 V through R1 = 680 Ω. D1 is reverse biased and holds Vref near its 5.1 V breakdown setting. The resistor supplies the sum of Zener current and reference-load current.
Q1 is an NPN emitter follower: its collector connects to the 12 V supply, base to Vref, and emitter to RL = 1 kΩ. The output is approximately 4.3 V. Most load current comes through Q1's collector, so the Zener node supplies only base current.
Vref is green, Vout red and load current blue. The follower improves current delivery but loses approximately one base-emitter drop. It does not remove the reference's temperature dependence.
Model limits. A reference needs enough resistor current to keep the Zener in breakdown. Below that point, output voltage falls with supply or load. Power ratings, Zener tolerances, noise, temperature drift and transistor heating are outside this example.
Try it. Set RL to 500 Ω; the transistor supplies about twice the load current. Restore the original values after comparing the results.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.