Inverting Amplifier
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Set a negative voltage gain with the ratio of two resistors.
Circuit notes
Inverting Amplifier
Set a negative voltage gain with the ratio of two resistors.
V1 applies a ±1 V, 100 Hz sine wave through R1 = 10 kΩ. RF = 20 kΩ returns the output to the inverting input; the noninverting input is grounded. Feedback holds the summing node close to zero without making it a physical ground connection.
The output is approximately ±2 V and inverted. The 10 kΩ load draws approximately ±200 µA. Resistor tolerance affects gain, while finite gain and bandwidth introduce small error and phase delay.
Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.
Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.
Try it. Set RF to 10 kΩ; the output amplitude equals the input with inverted polarity. Restore the original values after comparing the results.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.