Skip to main content

Noninverting Amplifier

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

3


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Amplify a voltage without reversing its polarity using a resistive feedback divider.

Circuit notes

Noninverting Amplifier

Amplify a voltage without reversing its polarity using a resistive feedback divider.

The ±1 V, 100 Hz input goes to the noninverting terminal. RF = 20 kΩ and RG = 10 kΩ return one third of the output to the inverting terminal. Feedback brings that divided voltage close to the input.

V−=VoutRGRF+RGV_- = V_{\mathrm{out}}\frac{R_G}{R_F+R_G} AV=1+RFRG=3A_V=1+\frac{R_F}{R_G}=3

The output is approximately ±3 V with the same polarity as the input. The 10 kΩ load current peaks around 300 µA. Increasing gain reduces the useful closed-loop bandwidth and eventually requires a larger output swing.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set RF to 10 kΩ; the voltage gain becomes two. Restore the original values after comparing the results.

Components used

Components used
3 components
NameManufacturerMPNCountType

Resistor

Generic

—

3

Official

AC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.