Follower
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Buffer a signal so a low resistance load draws current from the amplifier output.
Circuit notes
Follower
Buffer a signal so a low resistance load draws current from the amplifier output.
V1 drives the noninverting input with a ±1 V, 100 Hz sine wave. Direct output-to-inverting-input feedback creates a voltage buffer. The model draws little input current, while its output supplies the current in RL = 10 kΩ.
Green and red should almost coincide. The blue current peaks around 100 µA. Reducing the load to 1 kΩ raises current to about 1 mA. A physical buffer also needs suitable supply rails, output-current capability and stability for its load.
Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.
Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.
Try it. Set RL to 1 kΩ; the output remains near the input while load current increases tenfold. Restore the original values after comparing the results.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.