Skip to main content

Integrator (Inverting)

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Convert a square-wave voltage into an approximately triangular output with capacitive feedback.

Circuit notes

Integrator (Inverting)

Convert a square-wave voltage into an approximately triangular output with capacitive feedback.

V1 alternates between −1 V and +1 V at 500 Hz. R1 = 10 kΩ feeds the summing node and C1 = 100 nF provides feedback. RF = 100 kΩ across the capacitor gives a DC return and prevents indefinite drift. The saved view shows the final three cycles of a 200 ms run, after startup has decayed.

dVoutdt≈−VinR1C1\frac{dV_{\mathrm{out}}}{dt}\approx-\frac{V_{\mathrm{in}}}{R_1 C_1} ∣dVoutdt∣≈1000 V/s\left|\frac{dV_{\mathrm{out}}}{dt}\right|\approx1000\,\mathrm{V/s}

The output rises for negative input and falls for positive input, reaching approximately ±0.5 V in steady state. RF causes slight curvature because this is a practical leaky integrator. Startup begins from the simulator’s DC operating point, which is outside the saved final-cycle view.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set C1 to 200 nF; the steady-state ramp amplitude approximately halves. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

3

Official

Capacitor

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.