Skip to main content

Phase-Shift Oscillator Filter

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Inspect the attenuation and phase shift of the loaded three-section RC network used in a phase-shift oscillator.

Circuit notes

Phase-Shift Oscillator Filter

Inspect the attenuation and phase shift of the loaded three-section RC network used in a phase-shift oscillator.

V1 drives three cascaded high-pass RC sections, each using 10 nF and 10 kΩ. The sections load one another; they are not independent buffered filters. A1 buffers the last node so the 10 kΩ output load does not change that network.

H(s)=(sRC)3(sRC)3+6(sRC)2+5sRC+1H(s)=\frac{(sRC)^3}{(sRC)^3+6(sRC)^2+5sRC+1} f0=12πRC6≈650 Hz,H(f0)≈−129f_0=\frac{1}{2\pi RC\sqrt6}\approx650\,\mathrm{Hz},\qquad H(f_0)\approx-\frac1{29}

At 650 Hz the output is approximately 34.5 mV peak and nearly inverted relative to the 1 V peak input. Use the table or voltage-axis zoom to examine the smaller red waveform. This explains the phase and gain requirements of the related oscillator.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set V1 frequency to 1300 Hz; the filter has less attenuation and a different phase shift. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

4

Official

Capacitor

Generic

—

3

Official

AC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.