Skip to main content

Negative Impedance Converter

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

3


Schematic

Yes


Simulation

DC operating point


Copies

Not copied yet

About this circuit

Use powered feedback to make the current at a port oppose the direction expected from an ordinary resistor.

Circuit notes

Negative Impedance Converter

Use powered feedback to make the current at a port oppose the direction expected from an ordinary resistor.

V1 holds the input port at +1 V. A1 is noninverting with RF = RG = 10 kΩ, so its output is near +2 V. R1 = 10 kΩ connects output back to the input port. Current in R1 therefore flows toward the positive input source.

Iin=Vin−VoutR1I_{\mathrm{in}}=\frac{V_{\mathrm{in}}-V_{\mathrm{out}}}{R_1} Rin,eff=VinIin=−R1RGRF≈−10 kΩR_{\mathrm{in,eff}}=\frac{V_{\mathrm{in}}}{I_{\mathrm{in}}}=-\frac{R_1 R_G}{R_F}\approx-10\,\mathrm{k\Omega}

The table shows about −100 µA for Iin: the direction is defined from the source toward R1. This powered circuit delivers energy at its port; it is not a passive resistor. Negative resistance can destabilize other circuits, and its usable range is limited by amplifier swing and current.

Read the results. The saved operating-point table shows the probe values. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set RF to 20 kΩ; input current changes from about −100 µA to −200 µA. Restore the original values after comparing the results.

Components used

Components used
3 components
NameManufacturerMPNCountType

Resistor

Generic

—

4

Official

DC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.