Skip to main content

Gyrator

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Use a capacitor and a voltage follower to approximate a grounded inductance over a useful frequency range.

Circuit notes

Gyrator

Use a capacitor and a voltage follower to approximate a grounded inductance over a useful frequency range.

C1 = 100 nF and R1 = 100 kΩ feed a voltage follower. R2 = 100 Ω connects the input to the follower output. V1 applies a 0.1 V peak, 100 Hz sine wave. The feedback arrangement makes input current lag voltage much like a grounded inductor.

Leq≈R1R2C1=1 HL_{\mathrm{eq}}\approx R_1R_2C_1=1\,\mathrm{H} Zin≈R2+jωLeq(ωR2C1≪1)Z_{\mathrm{in}}\approx R_2+j\omega L_{\mathrm{eq}}\quad(\omega R_2C_1\ll1)

Vin is green, follower voltage red and total input current blue. The finite 100 Ω resistance is part of the approximation. This is a powered, grounded inductance simulation over a limited frequency range; it cannot replace a floating power inductor or store magnetic energy.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set C1 to 200 nF; the approximate inductance doubles and input current decreases. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

2

Official

AC Voltage Source

Generic

—

1

Official

Capacitor

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.