Emitter Follower
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Buffer a voltage with approximately unity small-signal gain and a base-emitter voltage offset.
Circuit notes
Emitter Follower
Buffer a voltage with approximately unity small-signal gain and a base-emitter voltage offset.
Circuit operation
The collector is tied to 5 V. V1 drives the base with a 1 V peak sine wave around 2.5 V; RE is the emitter load. The output is taken from the emitter.
Expected behavior
The output follows the input with the same phase and nearly the same AC amplitude, but sits roughly 0.7–0.8 V lower. The base-emitter drop changes with current, so the offset is not exactly constant.
Reading the results
The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.
The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.
Try a change
Set RE to 2 kΩ; compare the reduced emitter current and changed gain or bias. Restore the saved values after comparing the result.
Model limits
These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.