Skip to main content

Common-Emitter Amplifier

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

An emitter-degenerated transistor converts a small base-voltage change into an inverted collector-voltage change.

Circuit notes

Common-Emitter Amplifier

An emitter-degenerated transistor converts a small base-voltage change into an inverted collector-voltage change.

Circuit operation

V1 is a 50 mV peak sine wave around a 1.5 V base bias. RC is 4.7 kΩ and the unbypassed RE is 1 kΩ. The 12 V supply leaves room for the collector signal to move.

Expected behavior

IE≈VB−VBEREI_E\approx\frac{V_B-V_{BE}}{R_E} Av≈−RCRE+re,re≈VTIEA_v\approx-\frac{R_C}{R_E+r_e},\qquad r_e\approx\frac{V_T}{I_E}

The collector variation is inverted and several times larger than the input variation. Emitter degeneration stabilizes gain at the cost of amplitude. The chart uses separate ranges so the small input remains readable.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set RE to 2 kΩ; compare the reduced emitter current and changed gain or bias. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

2

Official

AC Voltage Source

Generic

—

1

Official

DC Voltage Source

Generic

—

1

Official

NPN BJT

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.