Skip to main content

Differential Amplifier

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

A transistor pair steers a shared tail current in response to a difference between its two base voltages.

Circuit notes

Differential Amplifier

A transistor pair steers a shared tail current in response to a difference between its two base voltages.

Circuit operation

The two NPN transistors share a 1.8 kΩ emitter-tail resistor and have equal 4.7 kΩ collector loads. One base stays at 2.5 V; the other receives a 20 mV peak signal around 2.5 V. Vdifference measures the left collector relative to the right collector.

Expected behavior

ΔIC=IC1−IC2ΔIC≈ITtanh⁡ ⁣(VB1−VB22VT)\begin{gathered}\Delta I_C=I_{C1}-I_{C2}\\\Delta I_C\approx I_T\tanh\!\left(\frac{V_{B1}-V_{B2}}{2V_T}\right)\end{gathered} Vleft−Vright=−RC(IC1−IC2)V_{left}-V_{right}=-R_C(I_{C1}-I_{C2})

An increasing left-base voltage steers current to Q1, lowering its collector and raising the opposite collector. Large differential inputs steer almost all tail current to one side. The resistive tail makes total current vary somewhat with common-mode voltage.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set V1 peak amplitude to 50 mV; compare common-mode response or nonlinear current steering. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

3

Official

DC Voltage Source

Generic

—

2

Official

NPN BJT

Generic

—

2

Official

AC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.