Skip to main content

Hartley Oscillator

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

5


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

An inductive divider supplies the feedback needed to sustain an LC oscillation.

Circuit notes

Hartley Oscillator

An inductive divider supplies the feedback needed to sustain an LC oscillation.

Circuit operation

Q1 is biased as a common-base amplifier. L1 and L2 form a series inductive divider, with CF coupling their tap to the emitter. C1 resonates with their total inductance.

Expected behavior

Leq=L1+L2(M=0)L_{eq}=L_1+L_2\quad(M=0) f0≈12π(L1+L2)C1f0≈48.0 kHz\begin{gathered}f_0\approx\frac{1}{2\pi\sqrt{(L_1+L_2)C_1}}\\f_0\approx48.0\,\mathrm{kHz}\end{gathered}

This version uses two uncoupled inductors. A tapped physical coil generally has mutual inductance, which changes the total to L1 + L2 + 2M for series-aiding windings. CF is 330 nF and RLOSS is 2.2 kΩ. Their loading shifts the settled frequency slightly below the ideal resonance estimate. The chart opens on the last 200 µs after startup.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 10.0 ms with a maximum step of 0.20 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set C1 to 20 nF; the resonant frequency decreases. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
5 components
NameManufacturerMPNCountType

Resistor

Generic

—

4

Official

Capacitor

Generic

—

3

Official

Inductor

Generic

—

2

Official

DC Voltage Source

Generic

—

1

Official

NPN BJT

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.