Skip to main content

SR Flip-Flop

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Cross-coupled NOR gates store one bit under separate active-high set and reset controls.

Circuit notes

SR Flip-Flop

Cross-coupled NOR gates store one bit under separate active-high set and reset controls.

Circuit operation

Two NOR gates feed each other. Set drives the complementary-output gate; Reset drives the Q gate. Small 100 Ω–1 nF output networks give the feedback loop finite settling time.

Expected behavior

S=1⇒Q=1R=1⇒Q=0\begin{gathered}S=1\Rightarrow Q=1\\R=1\Rightarrow Q=0\end{gathered} S=R=0⇒Qnext=QS=R=0\Rightarrow Q_{next}=Q

The output holds the last commanded state between pulses. S = R = 1 is forbidden: both NOR outputs go low and simultaneous release has no guaranteed result. This asynchronous SR latch is often called an SR flip-flop.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 8.0 ms with a maximum step of 2.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Increase the active set interval by setting VS low-pulse width to 3.398 ms. Q still holds its state after the command ends. Restore the saved values after comparing the result.

Model limits

Logic gates use ideal threshold models; storage elements include finite propagation delay. Unless a transistor or LED is explicitly drawn, internal supplies, input loading, output-current limits, and metastability are abstracted. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
4 components
NameManufacturerMPNCountType

Capacitor

Generic

—

2

Official

NOR 2-Input

Generic

—

2

Official

Pulse Voltage Source

Generic

—

2

Official

Resistor

Generic

—

2

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.