Simple Transmission Lines
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
A matched transmission line carries a pulse to its load after a finite propagation delay.
Circuit notes
Simple Transmission Lines
A matched transmission line carries a pulse to its load after a finite propagation delay.
Circuit operation
V1 drives a 50 Ω source resistor, a 50 Ω lossless line, and a 50 Ω load. T1 delay is 20 ns. Source and load termination both absorb returning waves.
Expected behavior
The green sending-end pulse rises near 10 ns and the red load pulse near 30 ns. The load pulse is 1 V and its current is 20 mA. A 20 ns delay corresponds to 4 m at an assumed propagation speed of 2×10⁸ m/s.
Reading the results
The first voltage probe is green and the second is red. Current probes start with blue. The schematic opens fitted to its extents. The transient runs for 400 ns with a maximum step of 0.2 ns. Compare sending and receiving waveforms with time-axis cursors. The table uses the same probe order.
Try a change
Double T1 delay to 40 ns; the load waveform keeps its amplitude and arrives 20 ns later. Restore the saved values after comparison.
Model limits
Each line is ideal and lossless: Z0 and TD are independent of frequency. Conductor and dielectric loss, dispersion, radiation, connectors, and breakdown are omitted. Line length is represented by propagation delay; the drawing is not a physical length scale. These examples describe differential line voltage relative to the shared return conductor.
References: Single-stub matching, distributed filter principles.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.