Skip to main content

Termination of a Transmission Line

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

3


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Compare matched, nearly open, and low-resistance loads to see the sign and size of reflected pulses.

Circuit notes

Termination of a Transmission Line

Compare matched, nearly open, and low-resistance loads to see the sign and size of reflected pulses.

Circuit operation

V1 launches a 1 V pulse into the 50 Ω line. The saved 50 Ω load produces no reflection. Change only RL to compare the two mismatch experiments.

Expected behavior

ΓL=RL−Z0RL+Z0\Gamma_L=\frac{R_L-Z_0}{R_L+Z_0} VL=V+(1+ΓL)V_L=V^+(1+\Gamma_L)

An approximately open load reaches 2 V; a 1 Ω load reaches about 39 mV. The reflected change arrives back at the input 40 ns after launch. The 50 Ω source absorbs it, so there is no endless train of reflections.

Reading the results

The first voltage probe is green and the second is red. Current probes start with blue. The schematic opens fitted to its extents. The transient runs for 400 ns with a maximum step of 0.2 ns. Compare sending and receiving waveforms with time-axis cursors. The table uses the same probe order.

Try a change

Set RL to 1 GΩ, approximating an open circuit. The load voltage doubles and the reflected pulse is positive.

Set RL to 1 Ω. The reflected pulse is negative and the load voltage is small. Restore the saved values after comparison.

Model limits

Each line is ideal and lossless: Z0 and TD are independent of frequency. Conductor and dielectric loss, dispersion, radiation, connectors, and breakdown are omitted. Line length is represented by propagation delay; the drawing is not a physical length scale. These examples describe differential line voltage relative to the shared return conductor.

References: Single-stub matching, distributed filter principles.

Components used

Components used
3 components
NameManufacturerMPNCountType

Resistor

Generic

—

2

Official

Lossless Transmission Line

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.