Mismatched Transmission Lines (Pulse)
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
A change in line impedance reflects part of an incoming pulse and transmits the rest.
Circuit notes
Mismatched Transmission Lines (Pulse)
A change in line impedance reflects part of an incoming pulse and transmits the rest.
Circuit operation
T1 is 50 Ω and T2 is 100 Ω; each delays the wave 10 ns. RL = 100 Ω matches T2, so the junction is the only major reflecting discontinuity.
Expected behavior
The launched 1 V pulse becomes about 1.333 V at the junction and load. The junction responds near 20 ns, the load near 30 ns, and the reflected step reaches the source near 30 ns. The source termination absorbs that returning wave.
Reading the results
The first voltage probe is green and the second is red. Current probes start with blue. The schematic opens fitted to its extents. The transient runs for 400 ns with a maximum step of 0.2 ns. Compare sending and receiving waveforms with time-axis cursors. The table uses the same probe order.
Try a change
Set T2 and RL to 50 Ω. The junction reflection disappears. Restore the saved values after comparison.
Model limits
Each line is ideal and lossless: Z0 and TD are independent of frequency. Conductor and dielectric loss, dispersion, radiation, connectors, and breakdown are omitted. Line length is represented by propagation delay; the drawing is not a physical length scale. These examples describe differential line voltage relative to the shared return conductor.
References: Single-stub matching, distributed filter principles.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.