Skip to main content

Mismatched Transmission Lines (Standing Wave)

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

3


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

An impedance step creates a standing-wave pattern even when the far load matches the second line.

Circuit notes

Mismatched Transmission Lines (Standing Wave)

An impedance step creates a standing-wave pattern even when the far load matches the second line.

Circuit operation

The first two sections are 50 Ω; the last two are 100 Ω. Each section delays the signal 2.5 ns. RL = 100 Ω matches the far end, while the midpoint impedance step reflects the incident wave.

Expected behavior

Γ12=100−50100+50=13\Gamma_{12}=\frac{100-50}{100+50}=\frac13 VSWR=1+∣Γ∣1−∣Γ∣=2\mathrm{VSWR}=\frac{1+|\Gamma|}{1-|\Gamma|}=2

In the first line, incident and reflected waves add with a position-dependent phase. In the matched second line, the transmitted wave travels toward the load without a further load reflection. Compare input, midpoint, and load amplitudes and phases after startup.

Reading the results

The first voltage probe is green and the second is red. Current probes start with blue. The schematic opens fitted to its extents. The transient runs for 400 ns with a maximum step of 0.2 ns. Compare sending and receiving waveforms with time-axis cursors. The table uses the same probe order.

Try a change

Set V1 to 12.5 MHz; the same physical line is now half as long electrically, changing the standing-wave pattern. Restore the saved values after comparison.

Model limits

Each line is ideal and lossless: Z0 and TD are independent of frequency. Conductor and dielectric loss, dispersion, radiation, connectors, and breakdown are omitted. Line length is represented by propagation delay; the drawing is not a physical length scale. These examples describe differential line voltage relative to the shared return conductor.

References: Single-stub matching, distributed filter principles.

Components used

Components used
3 components
NameManufacturerMPNCountType

Lossless Transmission Line

Generic

—

4

Official

Resistor

Generic

—

2

Official

AC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.