Stub Frequency Response
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
AC sweep
Copies
Not copied yet
About this circuit
An open shunt stub becomes a short at odd quarter-wave frequencies and creates periodic transmission notches.
Circuit notes
Stub Frequency Response
An open shunt stub becomes a short at odd quarter-wave frequencies and creates periodic transmission notches.
Circuit operation
A 50 Ω source and load are joined through a short main line. The 50 Ω shunt stub ends in 1 GΩ, approximating an open circuit. Its one-way delay is 10 ns.
Expected behavior
Transmission notches appear near 25, 75, 125, and 175 MHz. Near zero frequency the load is about 1 V for a 2 V AC source: 0 dBV, or a −6.02 dB voltage ratio. The source trace is 6.02 dBV. Subtract its dB value from the load trace to obtain voltage gain; phase is relative to the source.
Reading the results
The first voltage probe is green and the second is red. Current probes start with blue. The schematic opens fitted to its extents. The logarithmic Bode chart shows voltage magnitude in dBV and phase in degrees. The saved AC sweep spans 1–200 MHz with 150 points per decade. Deep notches may fall between frequency samples; increase sweep density to locate a minimum precisely.
Try a change
Set STUB delay to 5 ns; the first transmission notch moves from 25 MHz to 50 MHz. Restore the saved values after comparison.
Model limits
Each line is ideal and lossless: Z0 and TD are independent of frequency. Conductor and dielectric loss, dispersion, radiation, connectors, and breakdown are omitted. Line length is represented by propagation delay; the drawing is not a physical length scale. These examples describe differential line voltage relative to the shared return conductor.
References: Single-stub matching, distributed filter principles.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.