Skip to main content

3- and 4-Way Light Switches

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

DC operating point


Copies

Not copied yet

About this circuit

Control a low-voltage lamp from three locations using two end switches and an intermediate crossover switch.

Circuit notes

3- and 4-Way Light Switches

Control a low-voltage lamp from three locations using two end switches and an intermediate crossover switch.

Two end switches, SW1 and SW3, select one of two travelers. The middle DPDT switch, SW2, either connects the travelers straight through or swaps them. The lamp lights whenever there is a continuous path from the 12 V supply to the lamp.

The middle switch is represented by a voltage-controlled DPDT: VCTRL = 5 V selects straight-through contacts; VCTRL = 0 V selects crossed contacts. This control represents the handle position, not a conductor in a household installation. Both end switches start at State = 0.

The lamp model is a 120 Ω resistor. Each conducting contact contributes 0.1 Ω.

Ion≈12120+3(0.1)=99.75 mAI_{\mathrm{on}}\approx\frac{12}{120+3(0.1)}=99.75\,\mathrm{mA} Plamp=I2R≈1.194 WP_{\mathrm{lamp}}=I^2R\approx1.194\,\mathrm{W}

Read the results. The operating-point table shows Vlamp and Ilamp. The bulb symbol responds to its electrical power. Toggling any one of the three switches changes the lamp state; toggling two restores it.

Try it. Change either end switch’s State from 0 to 1, or change VCTRL’s DC voltage from 5 V to 0 V. Run the simulation after each change. Explore all eight combinations. Restore both end states to 0 and VCTRL to 5 V.

Model limits. This is a 12 V conceptual model. Contact bounce, arcing, mains wiring requirements and filament warm-up are outside the model. Off-state resistance is finite, so tiny leakage remains.

Components used

Components used
4 components
NameManufacturerMPNCountType

DC Voltage Source

Generic

—

2

Official

Switch - SPDT

Generic

—

2

Official

Dynamic Light Bulb

—

—

1

Official

Voltage Controlled DPDT

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.