Op-Amp Schmitt Trigger
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Use positive feedback to create separate rising and falling switching thresholds.
Circuit notes
Op-Amp Schmitt Trigger
Use positive feedback to create separate rising and falling switching thresholds.
V1 is a 100 Hz triangle spanning −5 V to +5 V, applied to the inverting input. RF = 30 kΩ returns output voltage to the noninverting input, and RG = 10 kΩ connects that node to ground. The amplifier output limits are approximately ±12 V.
As the input rises past +3 V the output switches negative. It does not switch positive again until the input falls below −3 V. That separation is hysteresis. Noise margins and real thresholds also depend on output swing, offsets and resistor tolerance.
Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.
Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.
Try it. Set RF to 50 kΩ; the switching thresholds move from about ±3 V to ±2 V. Restore the original values after comparing the results.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.