Skip to main content

Voltage-Controlled Oscillator

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

5


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Control an integrator current with a DC voltage while keeping the triangle switching thresholds fixed.

Circuit notes

Voltage-Controlled Oscillator

Control an integrator current with a DC voltage while keeping the triangle switching thresholds fixed.

VC = 2 V supplies a control voltage. A3 makes its negative counterpart. Two controlled switches alternately apply +VC or −VC to the integrator through 10 kΩ. A1 sets fixed triangle thresholds near ±4 V, while A2 integrates through 100 nF. Its 100 MΩ feedback return and the switch-node leakage resistor avoid ideal floating states.

∣dVtridt∣≈VCRC\left|\frac{dV_{\mathrm{tri}}}{dt}\right|\approx\frac{V_C}{RC} f≈VC4VTRC=125 Hz(VC=2 V)f\approx\frac{V_C}{4V_T RC}=125\,\mathrm{Hz}\quad(V_C=2\,\mathrm{V})

Triangle is green, Square red and triangle-load current blue. Raising VC increases slope and frequency while the thresholds stay nearly fixed. Initial capacitor charge starts the loop. The switches and amplifier limits are simplified; practical VCOs also have tuning-range, feedthrough, timing and temperature errors.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set VC to 4 V; the triangle slope and nominal frequency double. Restore the original values after comparing the results.

Components used

Components used
5 components
NameManufacturerMPNCountType

Resistor

Generic

—

8

Official

Capacitor

Generic

—

1

Official

DC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.