Skip to main content

Transmission-Line Light Switch

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

5


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

A distant resistive lamp responds only after the switched voltage propagates along its supply line.

Circuit notes

Transmission-Line Light Switch

A distant resistive lamp responds only after the switched voltage propagates along its supply line.

Circuit operation

A 12 V supply feeds a voltage-controlled switch, a 100 Ω source resistance, a 100 Ω line, and a 100 Ω resistive lamp model. V1 closes the switch near 0.1 ms. The line delay is deliberately long, 1 ms.

Expected behavior

tlamp≈tclose+TDt_{lamp}\approx t_{close}+T_D Plamp=VLIL≈0.36 WP_{lamp}=V_L I_L\approx0.36\,\mathrm W

The sending end reaches about 6 V shortly after closure; the lamp reaches about 6 V and 60 mA near 1.1 ms. The source resistance accounts for the other half of the supply voltage. The lamp is a fixed resistor: filament heating, light output, and temperature-dependent resistance are not modeled. At 2×10⁸ m/s, a 1 ms delay represents an illustrative 200 km line.

Reading the results

The first voltage probe is green and the second is red. Current probes start with blue. The schematic opens fitted to its extents. The transient runs for 4 ms with a maximum step of 2 µs. Compare sending and receiving waveforms with time-axis cursors. The table uses the same probe order.

Try a change

Reduce T1 delay to 0.5 ms. The lamp receives power about 0.5 ms after switch closure instead of 1 ms. Restore the saved values after comparison.

Model limits

Each line is ideal and lossless: Z0 and TD are independent of frequency. Conductor and dielectric loss, dispersion, radiation, connectors, and breakdown are omitted. Line length is represented by propagation delay; the drawing is not a physical length scale. These examples describe differential line voltage relative to the shared return conductor.

References: Single-stub matching, distributed filter principles.

Components used

Components used
5 components
NameManufacturerMPNCountType

Resistor

Generic

—

2

Official

DC Voltage Source

Generic

—

1

Official

Lossless Transmission Line

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.