555 Square Wave Generator
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
A 555 timer repeatedly charges and discharges a capacitor between its internal thresholds.
Circuit notes
555 Square Wave Generator
A 555 timer repeatedly charges and discharges a capacitor between its internal thresholds.
Circuit operation
RA charges CT through RB while the discharge transistor is off. At roughly two-thirds of VDD the latch resets, pulling DISCH low; CT then discharges through RB until it reaches one-third of VDD. The latch sets and repeats the cycle.
Expected behavior
With RA = RB = 10 kΩ and CT = 10 nF, expect about 139 µs high and 69 µs low: approximately 4.81 kHz at 67% duty. The first charging interval starts below the normal lower threshold and can be longer.
Reading the results
The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.
The saved transient runs for 3.0 ms with a maximum step of 0.10 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.
Try a change
Double CT; the oscillation period approximately doubles while the threshold voltages remain unchanged. Restore the saved values after comparing the result.
Model limits
The packaged timer uses supply-relative comparators and a stateful latch with finite output (100 Ω) and discharge (20 Ω) resistance. It models timer behavior, not IC supply current or thermal limits. Timing estimates ignore those resistances, leakage, comparator delay, and component tolerances. The internals example is a functional explanation rather than a transistor-level IC replica. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.
Reference: TI 555 timer datasheet.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.