Skip to main content

555 Monostable Multivibrator

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

5


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

A short negative trigger starts a much longer output pulse whose duration is set by an RC network.

Circuit notes

555 Monostable Multivibrator

A short negative trigger starts a much longer output pulse whose duration is set by an RC network.

Circuit operation

A short low pulse on TRIG sets the internal latch. The output rises and the discharge transistor releases CT. RT charges CT toward VDD until THRESH reaches two-thirds of VDD; the output then falls and CT resets.

Expected behavior

VC(t)=VDD(1−e−t/(RTCT))V_C(t)=V_{DD}(1-e^{-t/(R_TC_T)}) tp=RTCTln⁡3tp≈1.1RTCT\begin{gathered}t_p=R_TC_T\ln3\\t_p\approx1.1R_TC_T\end{gathered}

RT = 100 kΩ and CT = 10 nF give approximately 1.1 ms of output pulse from a 10 µs trigger. The 2 ms trigger period leaves time to reset the capacitor. The trigger must return high before the timing interval ends.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 6.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set RT to 150 kΩ; the output pulse increases from about 1.1 ms to 1.65 ms. Restore the saved values after comparing the result.

Model limits

The packaged timer uses supply-relative comparators and a stateful latch with finite output (100 Ω) and discharge (20 Ω) resistance. It models timer behavior, not IC supply current or thermal limits. Timing estimates ignore those resistances, leakage, comparator delay, and component tolerances. The internals example is a functional explanation rather than a transistor-level IC replica. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Reference: TI 555 timer datasheet.

Components used

Components used
5 components
NameManufacturerMPNCountType

Capacitor

Generic

—

4

Official

Resistor

Generic

—

2

Official

555 Timer

Generic

555

1

Official

DC Voltage Source

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.