555 Schmitt Trigger (inverting)
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
5
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Use the separate one-third and two-thirds supply thresholds to create an inverting input with hysteresis.
Circuit notes
555 Schmitt Trigger (inverting)
Use the separate one-third and two-thirds supply thresholds to create an inverting input with hysteresis.
Circuit operation
TRIG and THRESH share the triangle-wave input. Below one-third of VDD, the latch sets and Output is high. Above two-thirds of VDD, it resets and Output is low. Between those thresholds it remembers its state.
Expected behavior
At a 5 V supply, expect transitions near 1.67 V and 3.33 V. The output is inverted and has roughly 1.67 V of hysteresis. The 1 MΩ resistor lightly terminates the unused discharge output; it is not a timing resistor.
Reading the results
The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.
The saved transient runs for 6.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.
Try a change
Set V1 period to 4 ms and fall time to 2 ms; the switching thresholds stay near one-third and two-thirds of VDD. Restore the saved values after comparing the result.
Model limits
The packaged timer uses supply-relative comparators and a stateful latch with finite output (100 Ω) and discharge (20 Ω) resistance. It models timer behavior, not IC supply current or thermal limits. Timing estimates ignore those resistances, leakage, comparator delay, and component tolerances. The internals example is a functional explanation rather than a transistor-level IC replica. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.
Reference: TI 555 timer datasheet.
Components used
Components used
5 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.