Tunnel Diode Relaxation Oscillator
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
5
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
A biased tunnel diode and LC network repeatedly move between low- and high-voltage conducting branches.
Circuit notes
Tunnel Diode Relaxation Oscillator
A biased tunnel diode and LC network repeatedly move between low- and high-voltage conducting branches.
Circuit operation
A 0.25 V supply and 10 Ω source resistance bias the tunnel diode through L1 = 1 mH. C1 = 1 nF stores voltage across the diode. Initial current 3 mA and capacitor voltage 0.2 V start the circuit near its unstable middle branch.
Expected behavior
The inductor current ramps while the diode occupies one conducting branch, then the voltage jumps to the other branch near a turning point. The result is a relaxation waveform, not a sinusoidal LC oscillator. The chart opens on settled cycles near the end of the run.
Reading the results
The first voltage probe is green; the second, when present, is red. The first current probe is blue. The schematic opens fitted to its extents. The saved transient spans 1 ms with a maximum step of 0.02 µs. The chart uses separate voltage and current lanes, and the table retains the same probe order.
Try a change
Double L1 to 2 mH; the current ramps more slowly and the relaxation period increases. Restore the saved values after comparison.
Model limits
The diode uses a continuous piecewise-linear I/V curve with constant junction capacitance. It captures peak/valley behavior and negative differential resistance, but does not predict a particular diode’s tunneling physics, temperature behavior, noise, or high-frequency parasitics.
Reference: tunnel-diode modeling.
Components used
Components used
5 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.