Skip to main content

Elevador de Vidro Automotivo 12V – Subir Descer Parar

RU

rudogamichiyobi30

·

Created Oct 4, 2026

·

Updated Oct 4, 2026

Preview will appear once the owner saves the schematic
Details

Components

—


Schematic

Netlist only


Simulation

Transient analysis


Copies

Not copied yet

Tags

No tags yet.

About this circuit

The author hasn't added a description yet.

Circuit notes

I want to build and simulate an automatic power window circuit for a vehicle door in CircuitLab, using a 12 V DC power supply.

Components:

  1. 12 V DC battery/power supply
  2. 20–30 A automotive fuse
  3. Ignition switch (ON/OFF)
  4. Two 12 V, 30–40 A SPDT automotive relays
  5. One 12 V momentary DPDT switch with UP and DOWN positions
  6. One 12 V DC motor with two terminals
  7. Ground (GND)

Objective:

  • When the UP button is pressed, the motor must rotate in one direction.
  • When the DOWN button is pressed, the motor must rotate in the opposite direction.
  • When the DPDT switch is released, the motor must stop.
  • The DPDT switch must control the two relays in order to reverse the polarity applied to the motor.
  • The circuit must be protected by the fuse.
  • The ignition switch must act as the main enable/disable control for the system.

I want you to build the circuit in CircuitLab correctly and show:

  1. All components used.
  2. The terminals of both relays (30, 85, 86, and 87).
  3. The correct wiring of the DPDT switch.
  4. The correct connection of the battery, fuse, and ignition switch.
  5. The correct connection of the DC motor.
  6. All ground (GND/chassis) connections.
  7. The motor polarity when the UP button is pressed.
  8. The motor polarity when the DOWN button is pressed.
  9. The current flow path in both operating conditions.
  10. A step-by-step explanation of how to build the circuit in the simulator.

Use standard electrical symbols and clearly label every wire and terminal.

IMPORTANT: The circuit must be suitable for 12 V DC simulation and must prevent a short circuit across the battery. Carefully verify the relay logic and DPDT switching logic before presenting the final circuit.

The final circuit must work as follows:

IGNITION ON + UP pressed → Motor rotates in the UP direction. IGNITION ON + DOWN pressed → Motor rotates in the DOWN direction. IGNITION ON + DPDT released → Motor stops. IGNITION OFF → Motor cannot operate.

Please verify that the two relays correctly reverse the polarity across the motor without creating a short circuit.

Finally, provide a table with the following columns:

COMPONENT | TERMINAL | CONNECTION | FUNCTION

Components used

No component metadata available.

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.