2-Input AND Logic-Level Check

Application

This circuit uses the 2-Input AND as a small logic-condition detector. Two DC logic sources on the left provide the input states, and the gate output drives a light 10K load on the right.

Schematic Organization

Inputs A and B enter from the left, the featured 2-Input AND is centered, and the output node is measured with a digital probe before the load returns to ground.

Expected Behavior

With A and B both held at 5 V, Y should measure as logic high. Pull either input to 0 V and Y should measure low.

Suggested Experiments

Change either input source between 0 V and 5 V and rerun the transient simulation. The output digital series should go high only when both A and B are high according to the 2-Input AND truth table.

Featured Component

The featured component keeps the imported A, B, and Y pin arrangement while exposing rise and fall delay values for timing experiments.