Skip to main content

Full-Wave Rectifier with Filter

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Add a reservoir capacitor to a bridge rectifier and compare the charging peaks with the ripple between them.

Circuit notes

Full-Wave Rectifier with Filter

Add a reservoir capacitor to a bridge rectifier and compare the charging peaks with the ripple between them.

V1 supplies a 10 V peak, 100 Hz sine wave to the two AC terminals of the bridge. D1–D4 steer current through RL = 1 kΩ in the same direction on both half-cycles. Two diodes conduct in each path. Vin is measured across the floating source; its reference marker is the other AC terminal. Vout and Iload describe the DC side.

Vcharge,max≈Vin,pk−2VFV_{\mathrm{charge,max}}\approx V_{\mathrm{in,pk}}-2V_F fripple=2fin=200 Hzf_{\mathrm{ripple}}=2f_{\mathrm{in}}=200\,\mathrm{Hz}

C1 = 47 µF is connected across the load. It charges near each rectified crest and supplies the load while the bridge is off. The output is approximately 8 V with a small 200 Hz ripple; it is not regulated DC.

ΔV≈Iload2fC\Delta V\approx\frac{I_{\mathrm{load}}}{2fC}

At about 8 mA, the simple estimate gives 0.85 V peak-to-peak ripple. The actual ripple differs because charging takes finite time and diode drop changes with current. The simulation starts from an uncharged capacitor; the saved chart shows the final 30 ms of the 150 ms run.

Read the results. The green trace is the AC input, the red trace the rectified output, and the blue trace the load current. The voltage reference marker is a differential measurement connection, not a ground short across the source.

Model limits. D1–D4 use a generic junction model. The source and wiring omit transformer impedance, surge limits and thermal effects. These voltages are a low-voltage conceptual example.

Try it. Set C1 to 94 µF; compare the reduced steady-state ripple. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Diode

Generic

—

4

Official

AC Voltage Source

Generic

—

1

Official

Capacitor

Generic

—

1

Official

Resistor

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.