Skip to main content

DC Restoration

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Shift an AC waveform upward by charging a coupling capacitor through a diode clamp.

Circuit notes

DC Restoration

Shift an AC waveform upward by charging a coupling capacitor through a diode clamp.

V1 drives a ±5 V, 100 Hz sine wave through C1 = 1 µF. D1 has its anode at the return and cathode at the output. It conducts on negative excursions and charges C1 so the output's minimum stays near −0.7 V. RL = 1 MΩ slowly discharges the stored charge.

τ=RLC=1 s\tau=R_LC=1\,\mathrm{s} Vout,min≈−VF,Vout,max≈2Vpk−VFV_{\mathrm{out,min}}\approx-V_F,\qquad V_{\mathrm{out,max}}\approx2V_{\mathrm{pk}}-V_F

After the first negative crest, Vout spans roughly −0.7 V to +9.3 V. The capacitor shifts the waveform's DC level; it does not amplify the 10 V peak-to-peak signal. The 40 ms simulation includes startup and several restored cycles.

Read the chart. Vin is green and Vout red. Iload is blue. Compare their peak-to-peak swings and their different average levels.

Model limits. A finite load causes droop. Source resistance and diode charging current can matter in a physical clamp, and the stored voltage depends on the waveform's extrema.

Try it. Set RL to 10 kΩ and compare the increased tilt and loss of DC restoration. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

AC Voltage Source

Generic

—

1

Official

Capacitor

Generic

—

1

Official

Diode

Generic

—

1

Official

Resistor

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.