Skip to main content

Spike Generator

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Turn square-wave edges into brief pulses and suppress most of the negative-going pulse with a diode.

Circuit notes

Spike Generator

Turn square-wave edges into brief pulses and suppress most of the negative-going pulse with a diode.

V1 supplies 0–5 V pulses with 1 µs rise and fall times. C1 = 1 nF couples each edge to RL = 10 kΩ. D1 conducts when the output tries to go negative, reducing the negative pulse to about one diode drop. Positive edges produce larger short pulses.

τ=RLC=10 μs\tau=R_LC=10\,\mathrm{\mu s} vpulse(t)≈ΔV e−t/τv_{\mathrm{pulse}}(t)\approx\Delta V\,e^{-t/\tau}

The exponential expression describes an isolated ideal edge while the diode is off. Finite rise time makes the positive peak slightly less than 5 V. The input starts at 0.2 ms and repeats every millisecond; the saved 3 ms view includes three rising edges.

Read the chart. Vin is green, pulse output red and resistor current blue. Zoom horizontally to inspect an individual pulse, then return to the saved full view.

Model limits. This is an edge-shaping circuit, not a precise one-shot. Pulse width depends on the load, diode behavior and edge rate. Noise and fast parasitic effects are omitted.

Try it. Set C1 to 2 nF; the RC pulse-decay time doubles. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Capacitor

Generic

—

1

Official

Diode

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Resistor

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.