Skip to main content

AM Detector

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Recover a slowly changing amplitude envelope from a carrier with a diode and an RC hold circuit.

Circuit notes

AM Detector

Recover a slowly changing amplitude envelope from a carrier with a diode and an RC hold circuit.

V1 generates a 10 kHz carrier with 5 V peak amplitude, modulated at 100 Hz with modulation index 0.5. R1 = 100 Ω limits charging current. D1 charges C1 = 47 nF near positive carrier crests, and RL = 10 kΩ discharges it between them.

vin=5[1+0.5sin⁡(2π100t)]sin⁡(2π10,000t)v_{\mathrm{in}}=5[1+0.5\sin(2\pi100t)]\sin(2\pi10{,}000t) τ=RLC=470 μs\tau=R_LC=470\,\mathrm{\mu s}

The ideal envelope ranges from 2.5 V to 7.5 V. The recovered output is lower by the diode drop and charging loss in R1, and contains residual carrier ripple. The RC time is longer than a 100 µs carrier cycle and shorter than the 10 ms modulation cycle.

Read the chart. Carrier is green and Envelope red. The blue trace is load current. The saved view shows the final two modulation cycles, after startup.

Model limits. A larger RC reduces carrier ripple but can distort a falling envelope. A smaller RC follows the envelope faster but passes more ripple. Overmodulation, weak signals, diode threshold, noise and carrier frequency all affect detection.

Try it. Set V1 modulation index to 0.25; the recovered envelope varies less. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

2

Official

AM Voltage Source

Generic

—

1

Official

Capacitor

Generic

—

1

Official

Diode

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.