Skip to main content

Waveform Clipper

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Use DC bias references to set positive and negative clipping levels above the ordinary diode threshold.

Circuit notes

Waveform Clipper

Use DC bias references to set positive and negative clipping levels above the ordinary diode threshold.

V1 applies a ±5 V, 1 kHz sine wave through R1 = 1 kΩ. D1 conducts toward VP = +2 V when the output rises too far; D2 conducts from VN = −2 V when it falls too far. RL = 100 kΩ represents a light load.

Vupper≈2 V+VFV_{\mathrm{upper}}\approx2\,\mathrm{V}+V_F Vlower≈−2 V−VFV_{\mathrm{lower}}\approx-2\,\mathrm{V}-V_F

The plateaus are around ±2.7 V. Within these limits the output follows the input, with a small resistive-divider loss. The bias sources must absorb the diverted clipping current; they are ideal references in this model.

Read the results. Vin is green, Vout red and the input-resistor current Iin blue. The current plot shows where the source supplies clipping current.

Model limits. Ideal bias and signal sources have unlimited current capability. R1 is essential for limiting current. Junction capacitance, reverse recovery, heating and source impedance are omitted.

Try it. Set VP to +1 V and VN to −1 V; both clipping levels move toward zero. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

DC Voltage Source

Generic

—

2

Official

Diode

Generic

—

2

Official

Resistor

Generic

—

2

Official

AC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.