Skip to main content

Half-Wave Rectifier (Inverting)

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Rectify small negative input voltages with an op-amp and diode feedback.

Circuit notes

Half-Wave Rectifier (Inverting)

Rectify small negative input voltages with an op-amp and diode feedback.

A 0.2 V peak, 100 Hz input enters the inverting stage through 10 kΩ. RF is also 10 kΩ. One diode connects the amplifier output to the load; the other provides a feedback path during the blocked half-cycle, reducing deep saturation.

Vout≈max⁡(−Vin,0)V_{\mathrm{out}}\approx\max(-V_{\mathrm{in}},0) Iload≈max⁡(−Vin,0)10 kΩI_{\mathrm{load}}\approx\frac{\max(-V_{\mathrm{in}},0)}{10\,\mathrm{k\Omega}}

Negative input half-cycles become positive output half-cycles near 0.2 V peak. Positive input half-cycles give nearly zero output. Feedback compensates most of the diode drop, so signals well below 0.7 V can be rectified. Finite bandwidth still causes crossover error near zero.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set V1 peak voltage to 20 mV; the precision rectifier still produces a measurable output. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

3

Official

Diode

Generic

—

2

Official

AC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.