Skip to main content

Sine Wave Generator

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Generate a near-sinusoidal oscillation with a Wien bridge and diode-controlled gain.

Circuit notes

Sine Wave Generator

Generate a near-sinusoidal oscillation with a Wien bridge and diode-controlled gain.

R1 = R2 = 10 kΩ and C1 = C2 = 10 nF form a Wien lead-lag bridge. A1 amplifies its output. RF = 20.5 kΩ and RG = 10 kΩ give a small-signal gain of 3.05. A parallel feedback branch with RA = 100 kΩ and antiparallel diodes gently reduces gain as amplitude grows.

f0=12πRC≈1.59 kHzf_0=\frac{1}{2\pi RC}\approx1.59\,\mathrm{kHz} β(f0)=13,AV(f0)≈3\beta(f_0)=\frac13,\qquad A_V(f_0)\approx3

Bridge is green and the larger Sine output red. A 0.1 V capacitor initial condition supplies a reproducible startup seed. The final 6 ms view shows the settled waveform, about 0.9 V peak, after a 120 ms run. Diode amplitude control leaves distortion; a low-distortion oscillator needs smoother gain control and carefully chosen components.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set R1 and R2 both to 20 kΩ; the nominal oscillation frequency halves. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

6

Official

Capacitor

Generic

—

2

Official

Diode

Generic

—

2

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.