Skip to main content

Phase-Shift Oscillator

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

4


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Use three RC sections and an inverting amplifier to sustain an oscillation.

Circuit notes

Phase-Shift Oscillator

Use three RC sections and an inverting amplifier to sustain an oscillation.

Three 10 nF capacitors and three 10 kΩ resistances form a loaded phase-shift network. A1 is inverting. Its feedback resistance is 200 kΩ plus a 150 kΩ section shunted by antiparallel diodes, providing startup gain above the required value and reducing gain as the waveform grows.

f0≈12πRC6≈650 Hzf_0\approx\frac{1}{2\pi RC\sqrt6}\approx650\,\mathrm{Hz} ∣AV∣≳29at startup|A_V|\gtrsim29\quad\text{at startup}

The green filter voltage is much smaller than the red amplifier output. The RC network and amplifier inversion together provide a full loop phase rotation. A 1 mV initial capacitor voltage starts oscillation, and the saved final-cycle view follows startup. Diode limiting introduces distortion and shifts the ideal frequency slightly.

Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.

Model limits. The three-terminal op-amp model has implicit ±12 V output limits, 200,000 low-frequency gain and 10 MHz gain-bandwidth product. Supply pins are intentionally absent in this functional model. In Schmitt-trigger and relaxation/integrator oscillator examples, the switching amplifier uses a 100 kHz gain-bandwidth setting to resolve transitions cleanly at the saved time step. It omits detailed slew-rate, input common-mode, output-current and thermal limits.

Try it. Set C1, C2 and C3 all to 20 nF; the oscillation frequency approximately halves. Restore the original values after comparing the results.

Components used

Components used
4 components
NameManufacturerMPNCountType

Resistor

Generic

—

6

Official

Capacitor

Generic

—

3

Official

Diode

Generic

—

2

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.