MOSFET Switch
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Use a gate-voltage pulse to switch current through a resistive load.
Circuit notes
MOSFET Switch
Use a gate-voltage pulse to switch current through a resistive load.
V1 alternates between 0 V and 5 V at 1 kHz. The grounded-source n-channel MOSFET pulls the bottom of RD = 1 kΩ toward ground when on. A 5 V supply drives the resistor, so the circuit is a low-side switch.
Gate voltage is green, drain voltage red and load current blue. High gate voltage gives high load current and low drain voltage. The model has finite channel resistance, so the drain does not reach exactly zero. Small edge spikes come from the model’s intrinsic capacitances. The ideal gate source omits driver impedance; detailed switching loss and heating are outside this example.
Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.
Model limits. The generic level-1 MOSFET model is intended to explain bias and low-frequency behavior. It omits detailed subthreshold conduction, gate charge, body effects and thermal behavior; these are not part-specific design results.
Try it. Set RD to 500 Ω; on-state load current nearly doubles. Restore the original values after comparing the results.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.