Source Follower
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Follow a gate signal at the source while allowing the gate-source voltage needed to supply load current.
Circuit notes
Source Follower
Follow a gate signal at the source while allowing the gate-source voltage needed to supply load current.
The drain connects to 10 V. V1 applies a 0.25 V peak, 100 Hz sine wave on a 4 V gate bias. RS = 1 kΩ connects source to ground. The source rises until its current and the MOSFET overdrive are consistent.
At a 4 V gate bias, the source is near 1 V and current near 1 mA. The source waveform follows the gate with gain below one, roughly 2/3 near this bias. The DC difference is not a fixed threshold drop: additional overdrive is required to supply load current.
Read the results. The saved transient chart uses separate voltage and current panels; the table provides numerical samples. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.
Model limits. The generic level-1 MOSFET model is intended to explain bias and low-frequency behavior. It omits detailed subthreshold conduction, gate charge, body effects and thermal behavior; these are not part-specific design results.
Try it. Set RS to 2 kΩ; the source bias rises because less overdrive is required. Restore the original values after comparing the results.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.