MOSFET Current Source
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
3
Schematic
Yes
Simulation
DC operating point
Copies
Not copied yet
About this circuit
Use a fixed gate bias to keep drain current approximately constant while load voltage changes.
Circuit notes
MOSFET Current Source
Use a fixed gate bias to keep drain current approximately constant while load voltage changes.
V1 holds the gate at 3 V and the source is grounded. With a 2 V threshold and KP = 2 mA/V², the model’s nominal saturation current is 1 mA. RL = 1 kΩ connects the drain to a 10 V supply.
The drain is initially near 9 V. Increasing RL to 5 kΩ lowers it toward 5 V while current stays near 1 mA. Current stops being regulated when there is insufficient drain-source headroom. The model sets channel-length modulation to zero; real current varies somewhat with drain voltage.
Read the results. The saved operating-point table shows the probe values. The first voltage probe is green and the second red. The first current probe is blue; a second current probe is purple.
Model limits. The generic level-1 MOSFET model is intended to explain bias and low-frequency behavior. It omits detailed subthreshold conduction, gate charge, body effects and thermal behavior; these are not part-specific design results.
Try it. Set RL to 5 kΩ; the drain voltage changes while current remains near 1 mA. Restore the original values after comparing the results.
Components used
Components used
3 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.