CMOS Inverter (with capacitance)
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
6
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Charge and discharge an explicit capacitive load through the complementary output transistors.
Circuit notes
CMOS Inverter (with capacitance)
Charge and discharge an explicit capacitive load through the complementary output transistors.
Circuit operation
The p-channel device connects the output to the positive rail for a low input. The n-channel device connects it to ground for a high input. The two gate terminals share Vin. Compare the green input with the red output; Isupply is positive for current delivered by VDD.
CL is 100 nF. The output current must move charge into and out of this capacitor: . Compare edge slopes and supply-current pulses with the unloaded inverter example.
Expected behavior
For valid rail-level inputs, Vout approaches 5 V or 0 V and the supply current is very small. Near the switching point, both devices can conduct. The voltage equation describes the two logic endpoints, not a linear amplifier transfer law.
Reading the results
The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.
The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.
Try a change
Set CL to 10 nF; output edges become faster. Restore the saved values after comparing the result.
Model limits
These are generic transistor models, not a specific manufactured part. The CMOS models use illustrative threshold, transconductance, junction-capacitance and series-resistance parameters. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.
Components used
Components used
6 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.