Skip to main content

Switchable Filter

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

9


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

A transmission gate switches a shunt capacitor into an RC low-pass filter, changing its attenuation.

Circuit notes

Switchable Filter

A transmission gate switches a shunt capacitor into an RC low-pass filter, changing its attenuation.

Circuit operation

R1 stays in the signal path. The transmission gate connects CF from the filter output to ground when enabled, creating a low-pass filter. When disabled, CF is isolated and the output is mainly the resistive divider formed by R1 and RL.

Expected behavior

fc≈12πR1CFf_c\approx\frac{1}{2\pi R_1C_F} fc≈339 Hzf_c\approx339\,\mathrm{Hz}

R1 is 10 kΩ and CF is 47 nF. The 2 kHz input is strongly attenuated while the capacitor is connected. Compare settled intervals in each control state; switching charge and capacitor memory cause brief transitions.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Use the middle of settled plateaus for logic comparisons and the time-axis cursors for delays.

Try a change

Set V1 period to 2 ms and pulse width to 950 µs; compare the time scale of the response. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The 5 V circuits use illustrative threshold, transconductance, junction-capacitance and series-resistance parameters. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
9 components
NameManufacturerMPNCountType

Resistor

Generic

—

2

Official

4-Terminal NMOS

Generic

—

1

Official

4-Terminal PMOS

Generic

—

1

Official

AC Voltage Source

Generic

—

1

Official

Capacitor

Generic

—

1

Official

DC Voltage Source

Generic

—

1

Official

N-channel MOSFET

Generic

—

1

Official

P-channel MOSFET

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.