Current Source Ramp
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
4
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
A PNP current source charges a capacitor at an approximately constant rate.
Circuit notes
Current Source Ramp
A PNP current source charges a capacitor at an approximately constant rate.
Circuit operation
The PNP emitter resistor connects to 5 V and its base is held at 3.5 V. The collector charges a 1 µF capacitor from an initial 0 V. RL is a very light 10 MΩ leakage path.
Expected behavior
Expect a nearly straight rising ramp, about 0.7 V/ms at the saved bias. The initial-condition run can show a brief junction-capacitance current transient. As the capacitor approaches the emitter voltage, compliance is lost and the ramp flattens.
Reading the results
The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.
The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.
Try a change
Set RE to 2 kΩ; the collector current approximately halves. Restore the saved values after comparing the result.
Model limits
These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.
Components used
Components used
4 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.