Skip to main content

Bistable Multivibrator (Flip-Flop)

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

6


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Two cross-coupled transistor stages store one bit until a set or reset pulse changes the state.

Circuit notes

Bistable Multivibrator (Flip-Flop)

Two cross-coupled transistor stages store one bit until a set or reset pulse changes the state.

Circuit operation

Each collector drives the opposite base through 47 kΩ, forming two cross-coupled inverting stages. Brief set and reset pulses drive the two bases through isolation diodes, so inactive trigger sources do not load the stored state. A small initialized capacitor removes perfect startup symmetry.

Expected behavior

Q=Q‾‾Q=\overline{\overline Q} dQdt=0between commands\frac{dQ}{dt}=0\quad\text{between commands}

One collector stays high while the other stays low. Each command changes the stored state, which persists after the pulse ends. Simultaneous set and reset commands do not define a reliable final state.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set V1 pulse width to 100 µs; the circuit still holds its state after the pulse. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
6 components
NameManufacturerMPNCountType

Resistor

Generic

—

8

Official

Diode

Generic

—

2

Official

NPN BJT

Generic

—

2

Official

Pulse Voltage Source

Generic

—

2

Official

Capacitor

Generic

—

1

Official

DC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.